Flash programmers are useful for debugging programs on the MSP430/432 microcontroller. They allow you to program and erase flash memory directly from the computer, making debugging much easier.
You can also navigate to this website to find more about flash programmers for texas instruments.
Image Source: Google
To program in Flash Mode (serial comms), you will need the following:
1. A microcontroller with flash programming support, such as the Arduino.
2. A serial port on your computer (or on the microcontroller).
3. A programming cable to connect the microcontroller to your computer.
4. Flash software on your computer, such as Flash Builder or Eclipse.
5. The chip that you want to program (e.g., an ATMega328P for an Arduino).
6. jumper wires and a breadboard (if you are using an ATMega328P).
7. Some code examples or sketches that you want to program (e.g., a blinking LED circuit).
8. A voltmeter or multimeter to measure voltage and current levels (optional).
To set up the hardware for programming in Flash Mode (serial comms), follow these steps:
1. Plug the serial port of the microcontroller into the serial port of your computer, and connect the programming cable between them.
2. Install Flash Builder or Eclipse onto your computer, and open the project that you want to program in Flash Mode (e.g., a blinking LED circuit).
Software for debugging programs on the MSP430/432:
Debugging MSP430/432 programs can be a daunting task. The debuggers available for these microcontrollers are not always easy to use and can be quite complex.
This tutorial will walk you through the process of using a commercial MSP430/432 flash programmer to debug your programs.
This tutorial will provide you with step-by-step instructions on using a commercial MSP430/432 flash programmer to debug your programs.